Keep the Mold Away – Tack and Feed Room Ventilation

As we deal with heat and humidity, attention is often appropriately focused on the comfort of our animals.  We sometimes neglect to think about the impact of heat and humidity on our tack and on our feed.  Controlling humidity and temperature in areas where tack and feed are stored is also very important for the success of an equine operation.

Tack that is exposed to high humidity and warm temperatures can mold/mildew very quickly with resulting damage to leather.  The following steps might be useful to consider:

  1. Make certain there is adequate airflow thru the tack room. This may require having windows that allow ventilation or the addition of fans to move air thru the tack room.  Locate the air intake and air exhaust areas so that air flows thru the room, not just at ceiling level.  If you install exhaust fans, consider where the air will be coming in to reduce exposure to dust or contaminants.
  2. Do not store wet saddle pads/blankets in the same area as leather tack. Do not put pads/blankets over the top of saddles on saddle racks.
  3. Make certain there is space between saddle racks to allow airflow between saddles.
  4. Consider using a de-humidifier in the tack room. If possible, install so it drains automatically instead of requiring manual emptying of the water container.
  5. If design and electrical wiring are adequate, consider a window air conditioner for the tack storage area.

Feed room ventilation is also important.  Feed may absorb moisture from the air and mold even if it arrives at the farm at a suitable moisture level from the store or the feed plant.  If possible, store feed out of direct sunlight as moisture migration can take place within feed bags, causing moisture to accumulate in one area of the bag.  This is also a problem when feed is stored in bulk bins.  The feed on the sunny side can heat up and cause moisture migration in the bin.  The bin should be ventilated to allow moisture to escape but must be set up so moisture does not enter when it rains!  Depending on material, bins can be painted with reflective color to help reduce heating.

During warm, humid weather, do not buy large quantities of feed at one time and make certain the feed is rotated properly so that bags are used up and bins are emptied and cleaned/inspected regularly.  If bags are stacked, make certain that they are stacked on pallets or material that prevents moisture contact/accumulation at the bottom of the stack.  Stacking bags directly on top of concrete or dirt floor makes the bottom bags very prone to getting damp and molding.

Pest control is also important for both tack and feed storage areas.  Rodents can quickly damage tack and can contaminate feed.  Keeping the areas clean and using commercial pest control may be one option to consider.

Keeping both tack and feed protected from excess heat and humidity is an important part of barn design and barn management!

Leave a Reply

Your email address will not be published. Required fields are marked *